Instructions; Setting Operating Mode; Setting Room Values; Adjusting Curve Values - Danfoss DHP-AL User Manual

5

Instructions

An authorized installer carries out the basic settings of the heat pump at installation. You can
carry out the following yourself:

• Setting operating mode

• Setting ROOM values

• Adjusting CURVE values

• Adjusting a specific part of the heat curve
• Setting the desired maximum and minimum supply temperature
• Setting HEATSTOP
• Reading off the hot water temperature or different temperatures in the heat pump
• Calculate the heat pump's total energy consumption
• Defrost the outdoor unit
5 .1 Setting operating mode
In the control computer you can choose between five operating modes.
To change the operating mode:
1 Press either the right or left button once to open the INFORMATION main menu. The
cursor is in the OPERATION menu option.
2 Open your selection by pressing the right button once. An asterisk indicates the current
operating mode.
3 Mark the new desired operating mode using the up or down button.
4 Press the right button once to confirm your choice. The asterisk moves to your selected
operating mode.
5 Press the left button twice to exit the menu.
5 .2 Setting ROOM values
If the indoor temperature is too high or too low, you can adjust the ROOM value to change
the indoor temperature.
To change the ROOM value:
1 Press either the up or the down button once to open and change the ROOM value.
2 Raise or reduce the ROOM value using the up or down buttons to change the indoor
temperature.
3 Wait ten seconds or press the left button once to exit the menu.
5 .3 Adjusting CURVE values
To change the CURVE value:
1 Press either the right or left button once to open the INFORMATION main menu. The
cursor is in the OPERATION menu option..
2 Press the down button to move the cursor to the HEATCURVE menu option.
3 Open the menu by pressing the right button once.. The cursor is at CURVE.
4 Open your selection by pressing the right button once.
VUBMF102
Danfoss – 25