Danfoss DHP-AL User Manual page 21

3 .2 .4 Sub-menu TEMPERATURE
In the TEMPERATURE menu you are able to view the
various temperatures that the installation has had. All
temperatures are stored 100 minutes (factory setting)
back in time so that they can also be displayed in the
form of graphs.
Menu text
OUTDOOR
ROOM
SUPPLY PIPE
RETURN PIPE
HOT WATER
INTEGRAL
BRINE OUT
BRINE IN
Description
Outdoor temperature
If ROOM shows 20°C the heat curve is
unaffected. If ROOM shows higher or
lower, this indicates that the heat curve
has been adjusted up or down to change
the indoor temperature.
Shows the actual supply temperature.
(The desired value is shown between
brackets.)
Read the "Regulation information" section
for more information.
(In operating mode ADD.HEAT the stop
temperature for hot water production is
shown in brackets.)
Shows the read return temperature. (The
highest permitted temperature is shown
between brackets.)
Shows the actual hot water temperature.
Heat production is controlled by a
calculated demand that is automati-
cally calculated when the installation
is in operation. The integral is the heat
system's energy balance.
Read the "Regulation information" section
for more information.
The temperature of the brine circuit
going out from the heat pump.
The temperature of the brine circuit
going into the heat pump.
TEMPERATURE
OUTDOOR
ROOM
SUPPLY PIPE
RETURN PIPE
HOT WATER
INTEGRAL
BRINE OUT
VUBMF102
38(40)°c
34(48)°c
Adjusted by:
By the customer, if
necessary.
Not adjustable
(The computer calcu-
lates the temperature
required to maintain
the indoor tempera-
ture.)
Authorized installer.
Adjusted for each instal-
lation.
Not adjustable
Not adjustable
Not adjustable
Not adjustable
Danfoss – 21
0°c
20°c
52°c
-660
-7°c