Accessories; Room Temperature Sensor - Danfoss DHP-AL User Manual

7

Accessories

7 .1

Room temperature sensor

Contact your installer if you wish to supplement your heat pump installation with a room
temperature sensor, see the "References" section.
The room sensor is an accessory that is used to set a desired indoor temperature. It can be
installed in the house where the room temperature is relatively constant, not in a hallway,
kitchen or a room with alternative heating. On the room sensor you can set the desired room
temperature and view the outdoor temperature.
In the room temperature sensor there is a temperature sensor that provides a further value
that the control computer can use when calculating the supply temperature. The influence
of the room sensor in the calculation can be set in the menu HEAT CURVE-> ROOM FACTOR.
Default setting for ROOM FACTOR is 2 but can be adjusted from 1 (no impact) to 5 (large
impact).
• The room sensor's display shows the actual indoor temperature in normal mode.
• To display the outdoor temperature press the up and down buttons at the same time.
• To set the desired indoor temperature press either the up or down button.
• If the heat pump has an active alarm the text AL appears in the display.
VUBMF102
Danfoss – 33