Danfoss DHP-AL User Manual page 36

Term
Brine circuit
Refrigerant circuit
Refrigerant
Radiator
Control computer
ROOM
Heat transfer fluid
circuit
Heat curve
Danfoss – 36
Explanation
The fluid circuit transports energy from the heat source to the heat
pump. (See the "About your heat pump" section for further informa-
tion).
Is the circuit in the heat pump that through evaporation, compres-
sion and condensation takes energy from the brine circuit and sup-
plies it to the heat transfer fluid circuit. (See the "About your heat
pump" section for further information).
Is the fluid that transports heat from the brine circuit and supplies
it to the heat transfer fluid circuit. (See the "About your heat pump"
section for further information).
Heater element, element.
The control computer controls the entire heating installation. All
settings are stored and the history of the installation is registered
here. The control computer's settings can be changed via the dis-
play.
If ROOM shows 20°C the heat curve is unaffected. If ROOM shows
higher or lower, this indicates that the heat curve has been adjusted
up or down to change the indoor temperature.
The fluid circuit obtains heat/energy from the refrigerant circuit,
which it then transports to the water tank or heating system. See
the "About your heat pump" section for further information.
The control computer determines the correct temperature of the
water to be distributed to the heating system based on the heat
curve. The indoor temperature is adjusted by changing the gradient
of the heating system's CURVE.
VUBMF102