Table of Contents
Advertisement
7
Instructions
An authorized installer carries out the basic settings of the heat pump at installa-
tion. You can carry out the following yourself:
Setting operating mode
z
Setting ROOM values
z
Adjusting CURVE values
z
Adjusting a specific part of the heat curve
z
Setting the desired maximum and minimum supply temperature
z
Setting HEAT STOP
z
Reading off the hot water temperature or different temperatures in the heat
z
pump
Defrost the outdoor unit
z
7.1
Setting operating mode
In the control computer you can choose between five operating modes:
To change the operating mode:
1
Press either the right or left button once to open the INFORMATION menu.
The cursor is in the OPERAT. menu option.
2
Open your selection by pressing the right button once. An asterisk indicates
the current operating mode..
3
Mark the new desired operating mode using the up or down button.
4
Press the right button once to confirm your choice. The asterisk moves to your
selected operating mode.
5
Press the left button twice to exit the menu.
7.2
Setting ROOM values
If the indoor temperature is too high or too low, you can adjust the ROOM value to
change the indoor temperature.
To change the ROOM value:
1
Press either the up or the down button once to open and change the ROOM
value.
2
Raise or reduce the ROOM value using the up or down buttons to change the
indoor temperature.
3
Wait ten seconds or press the left button once to exit the menu.
VUBMI102
DHP-AX – 31
Advertisement
Table of Contents
