Regular Checks; Checking Operation; Checking The Brine Level - Danfoss DHP-AL User Manual

Hide thumbs Also See for DHP-AL:

Table of Contents

Regular checks

6 .1

During normal operation, the alarm indicator lights green continuously to show that every-

thing is OK. When the alarm is triggered, it flashes green at the same time as a text message

is shown in the display.

Regularly check the alarm indicator to ensure that the installation is working correctly. It

is not always the case that you will notice a problem with the installation, for example, in

the event of a fault with the compressor the auxiliary heater starts automatically (operating

mode AUTO). For further information about alarms, see the "Troubleshooting" section.

6 .2

The brine circuit must be filled with the correct amount of fluid otherwise the installation

may become damaged.

The brine must be topped up when the level drops so that it is no longer visible in the

expansion tank.

ALARM

LOWPRESS ERROR

Figure 13: Flashing alarm indicator in the event of an alarm .

VUBMF102

Danfoss – 29

Table of Contents