Instructions; Setting Operating Mode; Setting Room Values; Adjusting Curve Values - Danfoss DHP-H User Manual

5

Instructions

An authorized installer carries out the basic settings of the heat pump at installation. You can
carry out the following yourself:

• Setting operating mode

• Setting ROOM values

• Adjusting CURVE values

• Adjusting a specific part of the heat curve
• Setting the desired maximum and minimum supply temperature
• Setting HEATSTOP
• Reading off the hot water temperature or different temperatures in the heat pump
• Calculate the heat pump's total energy consumption
• For DHP-A: defrost the outdoor unit
5 .1 setting operating mode
In the control computer you can choose between five operating modes:
To change the operating mode:
1 Press either the right or left button once to open the INFORMATION main menu. The cur-
sor is in the OPERATION menu option.
2 Open your selection by pressing the right button once. An asterisk indicates the current
operating mode.
 Mark the new desired operating mode using the up or down button.
 Press the right button once to confirm your choice. The asterisk moves to your selected
operating mode.
 Press the left button twice to exit the menu.
5 .2 setting rOOm values
If the indoor temperature is too high or too low, you can adjust the ROOM value to change
the indoor temperature.
To change the ROOM value:
1 Press either the up or the down button once to open and change the ROOM value.
2 Raise or reduce the ROOM value using the up or down buttons to change the indoor
temperature.
 Wait ten seconds or press the left button once to exit the menu.
5 .3 adjusting CurVe values
To change the CURVE value:
1 Press either the right or left button once to open the INFORMATION main menu. The cur-
sor is in the OPERATION menu option.
2 Press the down button to move the cursor to the HEATCURVE menu option.
 Open the menu by pressing the right button once. The cursor is at CURVE.
Danfoss – 0 VUBMA102