Table of Contents
Advertisement
SUPERSERVER 6027PR-HC0(R/TR/FR) USER'S MANUAL
GLAN Enable/Disable
JPL1 enables or disables the LAN
Port 1 (JPLAN1) on the serverboard.
See the table on the right for jumper
set tings. The default set ting is
Enabled.
Watch Dog Enable/Disable
Watch Dog (JWD1) is a system moni-
tor that can reboot the system when
a software application hangs. Close
pins 1-2 to reset the system if an ap-
plication hangs. Close pins 2-3 to gen-
erate non-maskable interrupt signals
for the application that hangs. See the
table on the right for jumper settings.
Watch Dog must also be enabled in
the BIOS.
VGA Enable
Jumper JPG1 allows the user to
enable the onboard VGA connectors.
The default setting is 1-2 to enable the
connection. See the table on the right
for jumper settings.
BMC Enable
Jumper JPB1 allows you to enable
t h e o n b o a r d B M C ( B a s e b o a r d
Management) Controller to provide
I P M I 2 . O / K V M s u p p o r t o n t h e
serverboard. See the table on the
right for jumper settings.
GLAN Enable (JPL1)
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Watch Dog (JWD1)
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Open
VGA Enable (JPG1)
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
BMC Enable (JPB1)
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
5-20
Definition
Enabled (default)
Disabled
Definition
Reset (default)
NMI
Disabled
Definition
Enabled (Default)
Disabled
Definition
Enable (Default)
Normal
Advertisement
Table of Contents
