Table of Contents
Advertisement
SUPERSERVER 6027PR-HC0(R/TR/FR) USER'S MANUAL
LAN1 (Ethernet Ports)
A LAN (Ethernet) Port 1 is located
at JLAN1 on the I/O backplane
o n t h e s e r v e r b o a r d . T h i s L A N
port supports Gigabit_LAN on the
X9DRT-P/X9DRT-PIBF serverboards,
and supports 10G_LAN on the
X9DRT-PT serverboard. Additionally,
there is a dedicated LAN for IPMI on
top of the two rear USB ports. These
Ethernet ports accept RJ45 type
cables.
Note: Refer to the "Onboard Indicator"
section for LAN LED information.
Unit Identifier Switches
A Unit Identifier (UID) switch is located
at UIDSW2 on the I/O panel, and
a UID LED indicator is located at
UIDLED1 on the serverboard. When
the user presses the UID switch, the
UID LED indicator will be turned on.
Press the UID switch again to turn
off the LED indicator. The UID LED
Indicator provides easy identification
of a system unit that may be in need
of service. See the table on the right
for pin definitions.
Video Connector
A Video (VGA) connector is located
next to Fan 4 on the IO backplane. This
connector is used to provide video and
CRT display. Refer to the board layout
below for the location.
Pin Definitions
Pin# Definition
1
2
3
4
UID Switches & LEDs
Description
Rear Switch
Rear UID LED
5-16
UID Switch
(UIDSW2)
Ground
Ground
Button In
Ground
(UIDLED1)
Location
UIDSW2
UIDLED1
Advertisement
Table of Contents
