Planet GS-5220 User Manual page 54
L3 gigabit/10 gigabit managed poe switch
Hide thumbs
Also See for GS-5220:
- User manual (568 pages) ,
- Quick installation manual (16 pages) ,
- Quick installation manual (16 pages)
Table of Contents
Advertisement
duplex LC connector type.
To connect to 1000BASE-LX SFP transceiver, please use the single-mode fiber cable with one side being the male
duplex LC connector type.
Connecting the Fiber Cable
1.
Insert the duplex LC connector into the SFP/SFP+ transceiver.
2.
Connect the other end of the cable to a device with SFP/SFP+ transceiver installed.
3.
Check the LNK/ACT LED of the SFP/SFP+ slot on the front of the Managed Switch. Ensure that the SFP/SFP+
transceiver is operating correctly.
4.
Check the Link mode of the SFP/SFP+ port if the link fails. To function with some fiber-NICs or Media Converters, user
has to set the port Link mode to "10G Force", or "1000M Force".
Removing the Transceiver Module
1.
Make sure there is no network activity anymore.
2.
Remove the Fiber-Optic Cable gently.
3.
Lift up the lever of the MGB module and turn it to a horizontal position.
4.
Pull out the module gently through the lever.
Never pull out the module without lifting up the lever of the module and turning it to a horizontal
position. Directly pulling out the module could damage the module and the SFP/SFP+ module
slot of the Managed Switch.
User's Manual of GS-5220 PoE Series Managed Switch
Figure 2-2-5: How to Pull Out the SFP/SFP+ Transceiver
54
Advertisement
Table of Contents
