Table of Contents
Advertisement
owner's information
Remote / Receiver Coding
The remote control is coded at the factory.
If for what ever reason , the remote
requires to be recoded follow steps below.
To code the receiver to the hand-held remote,
follow the procedure below.
1. Remove screen assembly
2. Plug in 120 AC power cord into a grounded
receptacle, or install 4 AA batteries into the
backup battery holder located next to the
reset button. Do not use both 120 AC power
and batteries. Only use the 4 AA batteries if
120 AC is not available.
3. Install 3 AAA batteries into the hand-held
remote.
On / Off
Reset
Backup Battery
Switch
Button
Holder
4. Hold down the black reset button on the
left side until 3 beeps are heard.
5. Hold down the On / Off button on the
hand-held remote to code the remote to the
receiver. After 4 beeps are heard, the hand-held
remote is paired with the receiver
Backup Battery Holder
Insert 4 AA batteries into the backup battery holder as shown below.
Only use the 4 AA batteries if 120 AC is not available.
2 AA Batteries
2 AA Batteries
16
| Gi33 Direct Vent Gas Insert
Advertisement
Table of Contents
