Table of Contents
Advertisement
installation
Gi33 Hearth Trim Installation - Trimming to Height
(Part # 391-941)
Hearth Trim Installation - Trimming to Height
Part can only be installed with the Gi33 Regular Faceplate 391-910
or Regular Faceplate and Premium Surrounds (391-920/-921/-
922/-923/-924).
1. Remove the lower section of hearth trim by pulling evenly from
both sides.
2a. If using a grinder (recommended): Trim the lower section to
height refering to the installation table for the amount to remove.
2b. If using snips:
• Cut horizontally, refering to the installation table for the amount
to remove.
• Cut vertically along the corner to meet the previous cut.
• Cut horizontally across the front face.
• Repeat the process on the opposite side.
62
| Gi33 Direct Vent Gas Insert
920-690
2
1
2
3
1
3
1
3. Slide the lower section back into the clips on the rear of the upper
section.
Installation Table
Required install height
Height to cut off lower section
6" (Max)
None
5-1/2"
1/2"
2
5"
1"
4-1/2"
1-1/2"
4"
2"
3-1/2"
2-1/2"
3"
3"
2-1/2"
3-1/2"
2" (Min)
4"
1
3
05.25.23
Advertisement
Table of Contents
