Brother GTX600SB Instruction Manual page 288

Error code Error message
2012 [Ink refill: Cyan]
2013 [Ink refill: Yellow]
2014 [Ink refill: White]
[Cleaning Solution Out -
2015
Add More]
2016 [Ink refill: Green]
2017 [Ink refill: Orange]
2050 [Temp Low]
2051 [Temp High]
2055 [Humidity too Low]
2056 [Humidity too High]
[Obstacle Sensed on the
2070
Platen]
[Obstacle detected during
2071
print]
[Platen is too low
2072
Adjust the position]
Description
The remaining cyan ink
volume is below the specified
amount.
The remaining yellow ink
volume is below the specified
amount.
The remaining white ink
volume is below the specified
amount.
The remaining cleaning
solution volume is below the
specified amount.
The remaining green ink
volume is below the specified
amount.
The remaining orange ink
volume is below the specified
amount.
The ambient temperature
decreases below the
operation assurance range
for the best print result.
The ambient temperature
rises above the operation
assurance range for the best
print result.
The humidity is lower than
the operation assurance
range for the best print result.
The humidity is higher than
the operation assurance
range for the best print result.
The obstacle sensor has
detected some obstacle on
the platen or print medium.
The obstacle sensor has
detected some obstacle on
the platen or print medium
while printing.
The platen has been
detected to be too low when
attempting to start printing.
288
Remedy
Refill the cyan ink.
Refill the yellow ink.
Refill the white ink.
Refill cleaning solution.
Refill the green ink.
Refill the orange ink.
Raise your room temperature.
Lower your room temperature.
Turn on the humidification function and wait for
a while.
Lower your room humidity.
Remove such obstacle from the platen, flatten
its surface, and press the OK button to clear the
error.
Remove such obstacle from the platen, flatten
its surface, and press the OK button to clear the
error.
Perform test printing and check the ejection
from the head for any abnormalities.
If the ejection is abnormal, immediately perform
head cleaning to rectify the abnormality.
The gap between the medium's print surface
and the print head is too large. Make
adjustments by raising the platen.
Error message