Replacing The Flushing Foam - Brother GTX600SB Instruction Manual

6-1-8. Replacing the flushing foam

When a warning message appears on the operation panel screen or in the warning message window, replace the
specified flushing foam with a new one.
<TIPS>

Once you have selected [Maintenance Part Clean/Replace], you do not need to select it repeatedly in the case of replacing the
wiper, flushing foam, cap tip, cap foam, and carriage foam in sequence.

When you replace the flushing foam, check the staining state inside the printer. If parts inside the printer are stained, perform
cleaning. ☞"6-2-2. Cleaning and replacing maintenance parts >>P.233"
(1) Prepare the gloves and flushing foam (consumable supplies).
(2) From the menu, select [Maintenance] > [Maintenance Part Clean/Replace] > [Maintenance Unit Part Replace], and
press .
<IMPORTANT>

If any other error or message is displayed on the operation panel or warning message window, follow the message to solve
the problem, then perform the cleaning.

Please complete the task within 25 minutes, in order to prevent the print heads from drying up.

Then, the head cleaning will be performed to prevent any ink from drying up.
<TIPS>
 Pressing
(3) Unlock the upper left-hand-side cover and top cover and open them.
Keyhole
Precautions to keep good printing quality/use printer over the long term
causes the platen to start moving. Do not put anything around the platen.
Keyhole
192