Replacement Of Print Head - Brother GTX600SB Instruction Manual

6-1-12. Replacement of print head

If a problem of non-ejection of ink-jet droplets is not cleared even after cleaning the head nozzle, replace a The print
head with a new one.
Check the head position of the corresponding print head with the non-ejection of ink-jet droplets in the nozzle check
pattern, and replace the print head by following the procedure. ☞"6-1-17. Print out the nozzle check pattern (checking
on the print heads) >>P.220"
<TIPS>

Do not confuse the color/ORGR side print heads with the white side print heads.
Check the case color (red for the color/ORGR side heads and white for the white side head) and replace the case.

Color, OR/GR and white side print heads have side A and side B. Be sure to set them correctly.

Ink needs to be re-installed after replacing the print head. If the ink level is low, refill ink.
<NOTE>

For a proper work operation, be sure to wear the supplied gloves.
(1) From the menu, select [Maintenance] > [Head Replacement] > [Corresponding print head], and press
(2) Follow the on-screen message and turn off the power.
<IMPORTANT>

Please complete the task within 15 minutes, in order to prevent the print heads from drying up.
(3) Unlock the upper left-hand-side cover and top cover and open them.
Keyhole
Precautions to keep good printing quality/use printer over the long term
Keyhole
207
.