Replacing The Wiper - Brother GTX600SB Instruction Manual

6-1-6. Replacing the wiper

When a warning message appears on the operation panel screen, conduct replacement work.
<TIPS>

Once you have selected [Maintenance Part Clean/Replace], you do not need to select it repeatedly in the case of replacing the
wiper, flushing foam, cap tip, cap foam, and carriage foam in sequence.
(1) Have the supplied gloves and wiper ready.
(2) From the menu, select [Maintenance] > [Maintenance Part Clean/Replace] > [Maintenance Unit Part Replace], and
press .
<IMPORTANT>

If any other error or message is displayed on the operation panel or warning message window, follow the message to solve
the problem, then perform the cleaning.

Please complete the task within 25 minutes, in order to prevent the print heads from drying up.
<TIPS>

Pressing
(3) Unlock the upper left-hand-side cover and top cover and open them.
Keyhole
(4) Remove the wiper from the maintenance unit by pushing up the latch on the left side of the wiper.
Maintenance unit
Latch
Precautions to keep good printing quality/use printer over the long term
causes the platen to start moving. Do not put anything around the platen.
Keyhole
Wiper
187
Latch