Table of Contents
Advertisement
Note:
Ensure that the vent caps are tight and
level. If available, place a damp cloth over any
vent caps on both batteries.
3.
Connect the positive (+) cable clamp (red) to the
positive (+) terminal of the discharged battery
(Figure
79).
Note:
The positive-battery cable is wired to the
starter or solenoid.
1. Positive (+) cable on the discharged battery
2. Positive (+) cable on booster battery
3. Negative (–) cable on the booster battery
4. Negative (–) cable on the engine block
5. Booster battery
6. Discharged battery
7. Engine block
4.
Connect the other positive (+) cable clamp (red)
to the positive terminal of the booster battery.
5.
Connect the negative (–) cable clamp (black) to
the negative terminal of the booster battery.
6.
Connect the other negative (–) cable clamp
(black) to the engine block of the stalled machine
and away from the discharged battery.
Important:
Do not connect the negative (–)
cable clamp (black) to the negative battery
post of the discharged battery.
7.
Stand away from the discharged battery of the
machine.
8.
Start the machine and remove the cables in
the reverse order of connection, disconnect the
engine block connection first.
Servicing the Fuses
The electrical system is protected by fuses, and
requires no maintenance. If a fuse blows, check the
component or circuit for a malfunction or short.
1.
Remove the negative-battery cable from the
battery terminal; refer to steps
Removing the Battery (page
Figure 79
2
and
3
59).
Note:
does not touch the battery terminal.
2.
Push the tab on the fuse/relay holder and
separate the cover from the holder
3.
Pull the fuse from the socket of the fuse/relay
holder
g012785
1. Battery box
2. Cover
4.
Install a fuse of the same type (20 A) into the
socket of the fuse/relay holder
5.
Install the cover on to the fuse/relay holder until
it locks into place
6.
Install the negative-battery cable from the battery
terminal; refer to steps
Battery (page
of
61
Ensure that the negative battery cable
(Figure
80).
Figure 80
3. Fuses
4. Fuse/relay holder
(Figure
80).
5
and
60).
(Figure
80).
g027495
(Figure
80).
6
of
Installing the
Advertisement
Table of Contents
