Table of Contents
Advertisement
Filling the Spreader Hopper
Maximum hopper weight capacity: 79 kg (175 lb)
1.
Drive the machine to the work site.
2.
Move the machine to a level surface, move
motion-control lever to the N
shut off the engine, wait for all moving parts to
stop, remove key, and engage parking brake.
3.
Ensure that the wide-distribution impeller-gate
lever is in the fully forward (closed) position;
refer to
Wide-distribution Impeller-Gate Lever
(page
14).
4.
Use the
Spreading Charts (page 30)
determine the setting for the drop-rate cam
(Figure
26).
Note:
If the setting is not listed for the type of
material that you are using, set the cam to the
setting with a lower value then adjust as needed.
Figure 26
1. Cover
2. Hopper
5.
Remove the cover from the hopper, add the
material that you are spreading, and install the
cover onto the hopper
Note:
Do not overload the hopper; the
maximum weight capacity of the hopper is 79
kg (175 lb).
Note:
You may place 1 extra bag of granular
product on top of the sprayer tank if necessary.
position,
EUTRAL
to
g027326
3. Drop-rate cam
(Figure
26).
Emptying the Spreader
Removing the Impeller
1.
Move the machine to a level surface, move
motion-control lever to the N
shut off the engine, wait for all moving parts to
stop, remove key, and engage parking brake.
2.
Empty the hopper by scooping out as much of
the material as possible.
3.
Remove the 4 thumbscrews that secure the front
cover ( below the impeller) to the chassis, and
remove the cover
1. Forward cover
2. Clip nut
4.
Remove the drive pin that secure the impeller to
the shaft of the impeller motor, and remove the
impeller from the shaft
29).
1. Drive pin
2. Shaft
27
position,
EUTRAL
(Figure
27).
Figure 27
3. Thumb screw
(Figure 28
and
Figure
Figure 28
3. Impeller
g033530
g027324
Advertisement
Table of Contents
