Toro 34225 Operator's Manual page 46

Cleaning the Strainer
Service Interval: After each use
Important:
If you used wettable-powder
chemicals, clean the strainer after each time that
you rinse the sprayer tank.
1. Empty the sprayer tank; refer to
Sprayer Tank (page
2. Rotate the handle of the pump-shutoff valve 90°
counterclockwise to the
53).
Figure 53
1. Strainer
3. Align a drain pan under the strainer
4. Rotate the strainer bowl counterclockwise and
remove the bowl and screen from the body of
the strainer (Figure
Note:
Remove the strainer bowl by hand.
Note:
Replace the gasket or screen or both if
these parts are worn or damaged
Emptying the
40).
position (Figure
CLOSE
2. Pump-shutoff valve
(Figure
54).
g249175
1. Strainer body
2. Gasket
5. Allow any residual chemical solution to drain
53).
from the strainer body.
Note:
Dispose of the waste solution according
to local codes and the chemical manufacturer's
instructions.
6. Use a soft-bristle brush and clean water to clean
the screen and bowl
7. Install the screen into the strainer body
54).
8. Install the gasket and strainer bowl onto the
strainer body, and hand tighten the bowl
54).
9. Rotate the handle of the pump-shutoff valve 90°
clockwise to the
46
Figure 54
3. Screen
4. strainer bowl
position (Figure 53).
OPEN
g027402
(.Figure
(Figure