Table of Contents
Advertisement
Spraying Tips
1. Overlap area—narrow spray pattern
2. Effective spray area
3. Forward
4. Overlap area—wide spray pattern
5. 2.4 m (8 ft)
•
Do not overlap the effective spray area that you
have previously sprayed (see
•
Watch for plugged sprayer nozzles.
•
Move the narrow-and wide-spray pattern levers
to the O
position to stop the spray flow before
FF
stopping the motion of the machine. Once
stopped, leave the motion-control lever in N
and leave the sprayer-pump switch in the O
position.
•
You obtain better results if the machine is moving
when spray controls are turned O
•
Ensure adequate pump pressure for proper spray
distribution by push forward the tank-agitation
lever to the
position.
OFF
•
Watch for changes in the application rate.
Changes in the application rate indicate that your
ground speed has changed beyond the operating
range of the nozzles or there is a problem with the
sprayer system.
Note:
When the tank is nearly empty, the tank
agitation may cause foaming of the chemical solution
in the tank. In this case, push forward the tank
Figure 47
Figure
47).
EUTRAL
N
.
N
42
6. Sprayer Off—do not spray when turning the machine 180°
7. End of spraying job
8. Property fence
9. Gate
agitation lever to the
OFF
an anti-foaming agent compatible with the existing
chemical—add the anti-foaming agent according to
the manufacturer's instructions.
position. Alternatively, if
g027300
Advertisement
Table of Contents
