Preparing The Machine; Preparing The Tubing - Toro 41249 Operator's Manual

Procedure
3
4
5
6
7
Separate instructions for installing the foam marker kit are denoted in each step of the Setup, where specific
procedures are different from 1 machine to another. Please look for the heading describing instructions specific
to the machine that you are working with before proceeding with each step of the Setup.
Note:
This foam marker kit requires a mounting bracket specifically designed for your machine. Before
installing this kit, contact an authorized Toro distributor to obtain the Foam Marker Finishing Kit for your machine.
1

Preparing the Machine

No Parts Required
Procedure
CAUTION
Chemicals are hazardous and can cause
personal injury.
• Read the directions on the chemical labels
before handling the chemicals and follow
all manufacturer recommendations and
precautions.
• Keep chemicals away from your skin.
Should contact occur, wash the affected
area thoroughly with soap and clean water.
• Wear goggles and any other protective
equipment recommended by the chemical
manufacturer.
1. Park the machine on a level surface, engage the
parking brake, and shut off the sprayer pump.
Description
Regulating valve, cap mount
Regulating valve, mount
Decal (112-7890)
Foam marker finishing kit (sold
separately)
Foam tube
Cable ties
Compression nut (blue)
Compression nut (white)
Brackets
Spacers
Set screws
Mounting rod
Foam-nozzle assemblies
No parts required
Qty.
1
1 Install the foam control valve.
1
Install the foam marker finishing kit and
1
the bracket.
1
Route the foam tubes.
8
2
2
4
4 Install the foam nozzles.
4
2
2
–
Connect the boom section tubes.
2. Lower the outer booms.
3. Shut off the engine and remove the key.
4. Clean the sprayer; refer to Cleaning the Sprayer
in the machine Operator's Manual.
2

Preparing the Tubing

Parts needed for this procedure:
1 Foam tubing assembly (bulk)
Procedure
1. Measure the length of tubing from the bulk loop
and cut it according to the tables that follow.
Note:
Set aside the remaining tubing.
2. At each end of the cut tubing lengths, remove 7
to 10 cm (3 to 4 inches) of the black sheath to
expose the blue and clear tubing.
Note:
For Multi Pro 5000 Series machines, use
only a section of clear tube for the compressor
to tank loop.
2
Use