Toro 34225 Operator's Manual page 33

Figure 35
1. Deflector-gate control
2. Spreader-pattern control
3. Wide-distribution
impeller-gate lever
4. Narrow-distribution
impeller-gate lever
3. Move the throttle to the F
the machine forward.
4. Open the either the narrow or wide impeller-gate
lever to begin spreading
Note:
Use the narrow-spreader distribution
flow-rate knob to control the discharge rate
of the granular material from the hopper onto
the impeller when the narrow-distribution
impeller-gate lever is in the O
g033349
5. Narrow-spreader
distribution flow-rate
knob
6. Impeller On/Off switch
7. Impeller-speed control
position and drive
AST
(Figure 36).
position.
PEN
1. Wide spreader
pattern—variable effective
width to 6.7 m (22 ft)
maximum
5. Evaluate the spread pattern.
Note:
If you need to adjustment the spreading
pattern, refer to
(page 31).
6. When you are finished spreading, close the
wide-distribution impeller-gate lever.
Note:
Only the wide-distribution impeller-gate
lever closes the impeller gate. Pushing the
wide-distribution impeller-gate lever forward also
resets the narrow-distribution impeller-gate lever
to the forward position.
7. Clean the hopper after each spreading session;
refer to Cleaning and Lubricating the Spreader
(page 44).
Important:
Always empty and clean the
spreader immediately after each use. Failure
to do so may cause the chemicals to corrode
the spreader and other components.
33
Figure 36
2. Narrow spreader
pattern—variable effective
width from 1.5 m (5 ft)
minimum
Adjusting the Spreader Pattern
g027497