Toro 34225 Operator's Manual page 28

Figure 29
5. Place a shallow pan under the shaft of the
impeller motor (Figure
Disconnecting the Rate-Gate Linkage
1. Push the locking sleeve for the gate cable
rearward and lift the cable up from the ball stud
of the rate-gate linkage
g027325
29).
(Figure 30).
1. Locking sleeve
2. Gate cable
3. Ball stud
2. Pull the cable off the ball stud
3. Rotate the drop-rate cam past position-9 so
that the slot in the cam aligns with the linkage
(Figure 30).
4. Fully push the rate-gate linkage rearward
30).
5. If there is material in the hopper allow the
material to pour into a shallow pan; when the
hopper is empty, remove the pan.
28
Figure 30
4. Drop-rate cam
5. Rate-gate linkage
(Figure 30).
g027304
(Figure