Table of Contents
Advertisement
3.
Lock the spreader-pattern control by turning the
handle clockwise 90°; refer to 5 of
Using the Deflector Gate
Use the deflector-gate control to temporarily stop or
deflect granular material away from sidewalks, parking
lots, patios, or anywhere the granular chemicals are
not desired.
Note:
The deflector gate changes the discharged of
materials from the left side of the spreader only.
•
Push the knob for the deflector-gate control down
to lower the deflector and temporarily block the
granular material.
•
Pull the knob to raise the deflector to cast materials
normally at the left side of the machine.
1. Fence
2. Flowers
Figure
Figure 33
3. Deflector gate lowered
Spreading Material
32.
1.
Start the engine and place the throttle midway
between the S
2.
Set the impeller-speed control to appropriate
broadcast rate and then press the impeller
On/Off switch to the O
1. Indicator light
2. Impeller On/Off switch
3. Icon—press and hold the
impeller On/Off button 5
seconds
•
To lock the impeller speed control, press and
hold the impeller On/Off switch for 5 seconds
(Figure
Note:
On/Off switch will flash at a constant rate.
If the impeller-speed control is locked
g027373
(indicated by the flashing indicator light), the
impeller motor will start and run at the last
locked speed.
•
To unlock the impeller-speed control, start
the impeller motor and then press and
hold press and hold the On/Off switch for
5 seconds (the indicator light will illuminate
steadily).
32
and the F
LOW
AST
position
(Figure
N
Figure 34
4. Impeller-speed control
5. Spreader-motor and
sprayer-motor controller
34).
The indicator light above the impeller
positions.
34).
g027483
Advertisement
Table of Contents
