Table of Contents
Advertisement
1. Strainer (sprayer tank)
7.
Start the engine and set the throttle midway
between the S
LOW
8.
Set the sprayer-pump switch to the O
(Figure
43).
1. Sprayer-pressure control
2. Agitation-pump lever
3. Narrow-spray pattern lever 7. Sprayer-pump/tank-agitation
4. Wide-spray pattern lever
9.
Move the throttle to the F
10.
Pull rearward on the tank-agitation lever to the
O
position.
N
Note:
The water in the tank will circulate.
11.
Add the specified amount of chemical
concentrate to the tank as directed by the
chemical manufacturer.
Figure 42
2. Pump-shutoff valve
and F
positions.
AST
N
Figure 43
5. Spray wand
6. Sprayer-pressure gauge
switch
8. Sprayer-wand-pressure
control
position.
AST
Important:
wettable-powder chemical, mix the
powder with a small amount of water to form
a liquid slurry before adding the chemical
mixture to the tank.
12.
Add remaining water to the tank and install cap
onto the filler neck of the tank.
Note:
mix thoroughly.
Emptying the Sprayer Tank
Operator supplied equipment:
g027392
•
A drain hose with a 1/2–14 inch NPT male coupling
•
A drain container (capacity varies with remaining
sprayer tank content)
•
PTFE thread sealant
1.
Move the machine to a level surface at the
position
designated area for emptying and cleaning the
sprayer tank, move motion-control lever to the
N
EUTRAL
moving parts to stop, remove key, and engage
parking brake.
2.
Remove the plug from the drain valve for the
sprayer tank
Note:
of the machine.
g033348
1. Drain valve
3.
Thread a drain hose (operator provided) into the
end of the drain valve.
4.
Put the free end of the drain hose into a
container with enough capacity to hold the
remaining content of the sprayer tank.
40
If you are using a
Allow the content of the sprayer tank to
position, shut off the engine, wait for all
(Figure
44).
The drain valve is located at the left side
Figure 44
2. Plug
g025542
Advertisement
Table of Contents
