Advertisement
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
1
Preparing the Machine
No Parts Required
Procedure
1. Ensure that the machine is empty of all fluids. If
chemicals have been used in the machine, flush the
system thoroughly with clean water and drain the water;
refer to your vehicle Operator's Manual for instructions.
2. Disconnect the negative battery terminal from the
battery.
Description
No parts required
Hose hook
Flanged locknut (3/8 inch)
Flanged locknut (5/16 inch)
Carriage bolt (3/8 x 3/4 inch)
Carriage bolt (5/16 x 1 inch)
R-clamp
Spray-gun bracket
Female cap
Shutoff valve
Spray-gun valve
Hose-reel supply hose
Flange clamp
Gasket
Fitting, 90-degree
Hose clamp
Spray gun assembly
Straight barbed fitting
Hose clamp
Qty.
–
Prepare the machine.
1
4
4
Install the hose hook and spray-gun
4
bracket.
4
2
1
1
Install the shutoff valve (Multi Pro 1750
and Multi Pro WM only).
1
1
1
1
Install the control valve.
1
1
1
1
1
Connect the spray hose.
1
2
Installing the Hose Hook and
Spray-Gun Bracket
Parts needed for this procedure:
1
Hose hook
4
Flanged locknut (3/8 inch)
4
Flanged locknut (5/16 inch)
4
Carriage bolt (3/8 x 3/4 inch)
4
Carriage bolt (5/16 x 1 inch)
2
R-clamp
1
Spray-gun bracket
Procedure
1. Loosen the tank strap.
•
For the Multi Pro 1750 and Multi Pro 5800, loosen
the front, right strap
2
Use
(Figure
1).
Advertisement
