Table of Contents
Advertisement
3.
Remove the keypad (I) and front cover (D).
Note:
Remove the keypad, then move the keypad connector (E) to the holder (G) on the drive, then remove the front cover.
4.
Carefully remove the LED Status Ring board (M) and put it in the temporary placement holes (J) on the
right side of the drive.
Refer to the drive manuals for more information.
NOTICE
board, it can cause incorrect operation and damage to the drive.
5.
Install the option (B) into the CN5-A connector (N) on the drive and use the included screws (C) to put it in
place.
Tighten the screws to a correct tightening torque:
• 0.5 N∙m to 0.6 N∙m (4.4 lbf∙in to 5.3 lbf∙in)
Note:
1. A ground wire is not necessary. Do not use the ground wire.
2. Only two screws are necessary to install the option on a GA700, GA800, and CR700 drive.
6.
Firmly connect the Ethernet communication cables to CN1B (Port 2) (K), and/or CN1A (Port 1) (L).
Isolate communication cables from main circuit wiring and other electrical and power lines. Make sure that
you firmly connect the cable end. Refer to
information.
Note:
Maximum transmission distance is 100 m (328 ft). Minimum wiring distance between stations is 0.2 m (7.9 in).
7.
Reattach the LED Status Ring board (M), front cover (D), and keypad (I).
Refer to the drive manuals for more information.
NOTICE
comply could cause erroneous operation.
Note:
• Replace the keypad connector (E), then install the keypad.
• Put the keypad connector tab (F) into the holder when you install the keypad connector to the holder.
8.
Set drive parameters in
■
Procedure D
This section shows the procedure to install and wire the option on HV600 and FP605 drives.
Prepare the Drive for the Option
Correctly wire the drive as specified by the manual packaged with the drive. Make sure that the drive functions
correctly. Refer to the drive manuals for more information.
YASKAWA SIEP C730600 0IB Modbus TCP/IP Technical Manual
Do not remove the LED Status Ring board cable connector. If you disconnect the LED Status Ring
Do not pinch cables between the front cover or the LED Status Ring board and the drive. Failure to
Related Drive Parameters on page 20
Communication Cable Specifications on page 19
for correct option performance.
5 Installation Procedure
for more
17
Advertisement
Table of Contents
