Set Open Network Video Interface; Set Alarm Server - HIKVISION DS-2TD4238-7/S2 User Manual

Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
5. Click Save.
Register status turns to Online when the function is correctly set.

12.10 Set Open Network Video Interface

If you need to access the device through Open Network Video Interface protocol, you can
configure the user settings to enhance the network security.
Steps
1. Go to Configuration → Network → Advanced Settings → Integration Protocol .
2. Check Enable Open Network Video Interface.
3. Select an authentication mode.
- If you select Digest, the device only supports digest authentication.
- If you select Digest&ws-username token, the device supports digest authentication or ws-
username token authentication.
4. Click Add to configure the Open Network Video Interface user.
Delete Delete the selected Open Network Video Interface user.
Modify Modify the selected Open Network Video Interface user.
5. Click Save.
6. Optional: Repeat the steps above to add more Open Network Video Interface users.

12.11 Set Alarm Server

The device can send alarms to destination IP address or host name through HTTP, HTTPS, or ISUP
protocol. The destination IP address or host name should support HTTP, HTTP, or ISUP data
transmission.
Steps
1. Go to Configuration → Network → Advanced Settings → Alarm Server .
2. Enter Destination IP or Host Name, URL, and Port.
3. Select Protocol.
Note
HTTP, HTTPS, and ISUP are selectable. It is recommended to use HTTPS, as it encrypts the data
transmission during communication.
4. Click Test to check if the IP or host is available.
5. Click Save.
87