Set Alarm Host; Set Alarm Server; Set Network Service - HIKVISION DS-2TD2608-2/QA/FP User Manual

Thermal Optical Bi-spectrum Network Camera User Manual
2. Check Enable Open Network Video Interface.
3. Click Add to configure the Open Network Video Interface user.
Delete Delete the selected Open Network Video Interface user.
Modify Modify the selected Open Network Video Interface user.
4. Click Save.
5. Optional: Repeat the steps above to add more Open Network Video Interface users.

3.10 Set Alarm Host

The device can send the alarm signal to the remote alarm host when an event occurs. The alarm
host refers to the PC installed with client software.
Steps
1. Go to Configuration → Network → Other .
2. Enter the alarm host IP and port.
3. Click Save.

3.11 Set Alarm Server

The device can send alarms to destination IP address or host name through HTTP, HTTPS, or ISUP
protocol. The destination IP address or host name should support HTTP, HTTP, or ISUP data
transmission.
Steps
1. Go to Configuration → Network → Advanced Settings → Alarm Server .
2. Enter Destination IP or Host Name, URL, and Port.
3. Select Protocol.
Note
HTTP, HTTPS, and ISUP are selectable. It is recommended to use HTTPS, as it encrypts the data
transmission during communication.
4. Click Test to check if the IP or host is available.
5. Click Save.

3.12 Set Network Service

You can control the ON/OFF status of certain protocol as desired.
11