Comfort Options; Rika Room Sensor/Rika Radio Room Sensor; Rika Phone Option - Gsm; Rika Interface For Various Options - RIKA PICO Operating Manual

8. COMFORT OPTIONS

We would point out that auxiliary units may only be connected to the RIKA
interface connection and external connection socket by authorised specialists.

RIKA room sensor/RIKA radio room sensor

This option permits control of your stove via room temperature. You can set
both the room temperature and the heating times required. A room temperature
selected by you is observed during the heating times.
Please see the operating instructions for the option RIKA room sensor and
wireless room sensor for more detailed information.
RIKA phone option – GSM
Your stove can also be controlled via a mobile phone as an additional option.
Please see the operating instructions for the telephone option – GSM for more
detailed information.

RIKA interface for various options

for various options
The RIKA ROOM SENSOR, the RIKA WIRELESS ROOM SENSOR and the RIKA
PHONE OPTION – GSM are to be connected to the interface (stove rear) using
the connection cable supplied.

External room thermostat

Your stove has an interface on the rear wall to which you can connect a
customary room thermostat. This requires a 2-pole cable of 0.5 – 0.75 mm²
cross-section that you have to connect instead of the cable bridge fitted for
delivery

External connection cable bridge

(condition as delivered)
The stove settings in the menu item Setup are to be checked to ensure the
function of the room thermostat. The external unit must be set to EXT ON
(active) as described above.
This function enables you to deactivate a connected room thermostat (setting
EXT OFF).
All further settings required to your thermostat can be taken from the room
thermostat operating instructions.
The connected room thermostat must be operated in the HEAT menu. You can
select the heat output you wish for the room temperature selected.
If an external demand for stopping the pellet stove occurs, it takes about 5
minutes until the pellet stove switches to burn out phase.
Note
Operation is not possible unless either a cable bridge or an external room
thermostat is connected. The external demand has priority over all operating
modes (EASY/HEAT/AUTOMATIC/ROOM).