Stopping During Ignit Or Startphase; Easy 40 - Operation; Cleaning And Tipping During Operation; Easy 40 - Switch Off - RIKA PICO Operating Manual

key display
EASY OFF
Pressing
IGNIT
This is shown by IGNITE in the display; this is
START
replaced by START after a brief time.
EASY xx appears in the display after the
EASY 35 start phase (xx stands for a value between
30% and 100%, depending on output)
IGNIT
START
to change the power setting
press „+" or „-" keay (the setting will be changed in 5% steps

Stopping during ignit or startphase

If switching off occurs again 50 sec. within switching on (
sec. -key), the pellet stove returns to inactive status.
If switching off occurs during the ignition process (IGNIT or START) (at least 2
sec. -key), IGNIT OFF or START OFF appears in the display and the burn-out
phase is initiated. The pellet support stops - the flue gas fan continues to burn
any pellet residues (approximately 10 minutes). The stove changes to EASY
OFF.
EASY 40 – operation
key display
Standard display for stove switched on in
EASY 40
simple heating mode. (40 is the output in %)
EASY 45 Pressing increases output by 5%
EASY 40 Pressing decreases output by 5%
description
starts the unit.
EASY
O FF
single press
EASY
50
-key) (at least 2
description

Cleaning and tipping during operation

The automatic cleaning process is conducted every hour for approx. 2 minutes.
During this phase the air vents that are necessary for combustion are blown
clean.
Great cleaning phase (only stoves with automatic turning grid):
The pellet stove enters the burnout phase every 7 hours. A tipping process is
conducted automatically. The start-up phase is automatically re-initiated after
completion of the burnout phase and operation continues
EASY 40 – switch off
key display
The burnout phase is initiated by pressing for
at least 2 seconds (until the change is visible
STOP on the display). The pellet support stops -
the flue gas fan continues to burn any pellet
EASY OFF
residues (approximately 10 minutes).
The stove changes to EASY OFF.
pressing the button
(until the change is visible
on the display)
description
EASY
O FF
single press
IGNIT
START
EASY
50
change power setting by
pressing the „+" or „-" key
(change in 5 % increments)
|15
14