Gas Fl Ow Rate - TESTO 340 Instruction Manual

Recording smoke tester no. / smoke numbers / oil derivative with the smoke tester
testo 308 and wireless transfer:
- t308 must be in Data Mode (
1 Press function key
- The values recorded by the smoke tester are transferred.
2 Once all values have been transferred, select function key
Entering the heat carrier temperature:
Copying values to the Flue gas menu:
- The
G.2.5 Gas fl ow rate
The
Calling up the function:
Measuring:
1 Enter the measurement period:
2 Start measuring:
- The remaining measurement period is displayed.
- When the measurement period has lapsed, a long beep is emitted. The last 5 s are
3 Enter the fl ow rate:
- The calculated gas burner output is displayed.
4 Copy the values to the
- The
information@ITM.com
t308 .
 Enter the value 
Heat carrier Change

The values are not shown on the instrument's display. In the menu
be stored and/or printed in a measurement protocol together with the readings from
a fl ue gas measurement, or transferred to a PC
.
OK Copy readings OK

menu is opened.
Measurements
function is only available if the activated fuel is a gas.
Gas flow rate
Measurements OK
  
seconds)  OK .
180
Start . Note the counter status of the gas counter.
indicated by a short beep.
 Enter the value 
Gasflow
Flue gas
menu is opened.
Measurements
www.
).
OK
.
OK
Gas flow rate OK .

Change  Enter the value (
Sample time

OK .
menu: OK
OK Copy readings

Testo-Direct
41
.
, they can
Flue Gas
,
18 36, or
.
1.800.561.8187
.ca