Gas Fl Ow Rate - TESTO 340 Instruction Manual

Recording smoke tester no. / smoke numbers / oil derivative with the smoke tester
testo 308 and wireless transfer:
- t308 must be in Data Mode (
1 Press function key
- The values recorded by the smoke tester are transferred.
2 Once all values have been transferred, select function key
Entering the heat carrier temperature:
Change
Heat carrier

Copying values to the Flue gas menu:
The values are not shown on the instrument's display. In the menu
be stored and/or printed in a measurement protocol together with the readings from
a fl ue gas measurement, or transferred to a PC
OK Copy readings

- The
Measurements
G.2.5 Gas fl ow rate
The function is only available if the activated fuel is a gas.
Gas flow rate
Calling up the function:
Measurements

Measuring:
1 Enter the measurement period:
seconds) 
180
2 Start measuring:
- The remaining measurement period is displayed.
- When the measurement period has lapsed, a long beep is emitted. The last 5 s are
indicated by a short beep.
3 Enter the fl ow rate:
- The calculated gas burner output is displayed.
4 Copy the values to the
- The
Measurements
).
.
t308
 Enter the value 
.
OK
menu is opened.
OK
Gas flow rate
 
Sample time
.
OK
Start . Note the counter status of the gas counter.
 Enter the value 
Gasflow
menu:
Flue gas OK Copy readings
menu is opened.
Testo-Direct
www.
OK .
OK .
.
OK

 Enter the value (
Change

OK .
OK .

, they can
Flue Gas
,
18 36, or
1.800.561.818
.ca
41