E.5.2 Location
Creating a new location:
A location is always created in a folder.
1 Select the folder
2 Select the
3 Enter values
4 Repeat steps 2 and 3 for the other criteria accordingly.
5
Ordering the locations list:
1 Select the folder
2
Activating a location:
- The location is activated and the
Restoring the locations list:
Delete a location:
1 Select the folder
2 Select the location
3 Select
Performing location settings:
For fl ow speed, air fl ow and mass fl ow to be measured correctly, the shape and surface
area of the cross-section must be set.
The parameters
fl ow and mass fl ow. The Pitot factor is dependent on the Pitot tube used:
· Straight Pitot tubes (0635 2041, 0635 2042): Pitot factor 0.67
· Prandtl (curved) Pitot tubes (0635 2145, 0635 2345): Pitot factor 1.00
The correction factor refers to the stated areas. If part of the area is covered (e.g. by gril-
le bars), this can be compensated via the correction factor. The free portion of the area
should be given (e.g.. 20% covered and 80% free: correction factor 0.8). The correction
factor should be set at 1.00 for all standard applications.
information@ITM.com
OK
New location
Location name
Change
OK Save input
or
OK Go to measurement
OK To location
.
OK
OK
.
Locations list
Select the folder
OK
Select location
To arrange the list in the order in which the folders were created:
Select the folder
OK
Restore list
OK
.
Edit
.
Delete site with data
and
Pitot factor
Offset factor
www.
OK
.
.
OK
.
OK
.
OK
.
menu is opened.
Measurements
OK
.
.
OK
infl uence the measurement of fl ow speed, air
Testo-Direct
23
1.800.561.8187
.ca