Program - TESTO 340 Instruction Manual

Measuring:
1 Start measuring:
- The readings are displayed.
2 Stop measuring:
G.2.2 Program
Five fl ue gas measuring programs can be set, saved and run.
Calling up the function:
Changing a measuring program:
1 Select the program 
2
3 Repeat step 2 for the other criteria accordingly.
4
Running a measuring program:
1 Select the program 
2 Select
- If selected: Gas zeroing (32 s).
- Stabilisation phase (60 s).
- The program will run and then stop after the programmed time.
information@ITM.com
Start .
Option:
Interrupt measurement and rinse sensors:
Continue measurement: Gas
Stop .
Options:
To print readings: Print .
To save readings: Save .
- The readings from the fl ue gas measurement, as well as any readings taken over
into the menu Flue Gas from other measurement functions are stored and/or prin-
ted in a measurement protocol (automatic furnace data are not printed).
Measurements OK
  
Change .
Change Enter the values 
Meas rate

OK .
OK Save input

.
Start
(only available if gas zeroing has already been carried out)
Start without zeroing
or and start the program with
Start with zeroing
Option:
To print readings: .
Print
To cancel the program: Stop
www.
Air ,
.
.

Program

OK

OK .
OK .
, start again: Start .
Testo-Direct
39
1.800.561.8187
.ca