Gas Flow Rate - TESTO 340 Instruction Manual

Recording smoke tester no. / smoke numbers / oil derivative with the smoke tester
testo 308 and wireless transfer:
- t308 must be in Data Mode (
1 Press function key
- The values recorded by the smoke tester are transferred.
2 Once all values have been transferred, select function key
Entering the heat carrier temperature:
Heat carrier
Copying values to the Flue gas menu:
The values are not shown on the instrument's display. In the menu
be stored and/or printed in a measurement protocol together with the readings from
a flue gas measurement, or transferred to a PC
OK Copy readings
- The
Measurements
G.2.5 Gas flow rate
The function is only available if the activated fuel is a gas.

Gas flow rate

Calling up the function:
Measurements
Measuring:
1 Enter the measurement period:
seconds)
180
2 Start measuring:
- The remaining measurement period is displayed.
- When the measurement period has lapsed, a long beep is emitted. The last 5 s are
indicated by a short beep.
3 Enter the flow rate:
- The calculated gas burner output is displayed.
4 Copy the values to the
- The
Measurements
.
t308
Enter the value
Change
.
OK
menu is opened.
OK Gas flow rate
Sample time
.
OK
. Note the counter status of the gas counter.
Start
Enter the value
Gasflow
menu:
Flue gas
menu is opened.
).
.
OK
.
OK
Change
OK
OK Copy readings
.
OK
Flue Gas
Enter the value (
.
.
OK
G. Measuring 41
, they can
,
18 36, or