Protocols - TESTO 340 Instruction Manual

24
information@ITM.com
The parameters (ambient air temperature),
Temp./amb.
and (ambient air dew point) infl uence calculation of the qA (Flue gas loss)
Dew p./amb.
and DP (Flue gas dew point temperature). The parameters should be set to the factory
settings for all standard applications (Temp./amb.: 20.0 °C, Hum/amb.: 80.0 %, Dew p./
amb.: 16.4 °C). To achieve greater accuracy, the values can be adjusted to the actual
ambient conditions.
If the ambient air temperature sensor is plugged in, the value for Temp./amb. is accep-
ted automatically. The parameter
and via the function key
amb. Hum/amb.
1 Select the folder  .
OK
2 Select the location  Edit
Options:
To set the shape of the cross-section:
Change  Select the cross-section 
Cross section

To set the surface area of the cross-section:
 Select the cross-section 
Cross section Change

OK .
To set parameters:
Select the parameter 
3 OK To location OK .

E.5.3 Protocols
Printing/deleting all protocols :
Select the folder  OK  Select a location 
- The saved protocols are displayed. Protocols of measurement programs are marked
with a vertical line and the number of individual measurements (e.g.
than 999 measurements dots are used (
a measurement protocol the following symbol is displayed next to the protocol name:
. The data are printed with the protocol printout.
Options:
To print all data: Print all 
To delete all data: Delete all 
www.
Hum/amb.
can be calculated from the values of
Dew p./amb.
calc .
.
Change  Set the values  OK
Data .
). If automatic furnace data are stored with
|...
.
OK
OK .
Testo-Direct
(ambient air humidity)
Temp./
 .
 Set the values 
Change
.
), for more
|245
1.800.561.8187
.ca