Baud Rate; Reset - Optoma ZU1100 User Manual

USING THE PROJECTOR
AMX
Control the projector with AMX devices. (Port: 9131)
For more information, please visit http://www.amx.com.
Telnet
Control the projector using RS232 commands though Telnet connection. (Port: 23)
For more information, refer to "Using RS232 command by Telnet" on page 76.
HTTP
Control the projector with web browser. (Port: 80)
For more information, refer to "Using the web control panel" on page 73.
Optoma Management Suite (OMS)
Control the projector with OMS.
For more information, please visit https://www.optoma.com.

Reset

Reset the control functions to default factory values.
Note:
‡ Crestron is a registered trademark of Crestron Electronics, Inc. of the United States.
‡
Extron is a registered trademark of Extron Electronics, Inc. of the United States.
‡
AMX is a registered trademark of AMX LLC of the United States.
‡
PJLink applied for trademark and logo registration in Japan, the United States of America, and other
countries by JBMIA.
‡
For more information about the various types of external devices which can be connected to the LAN
/ RJ45 port and remotely control the projector, as well as the supported commands for these external
devices, please contact the Support-Service directly.

Baud Rate

Set the baud rate for Serial Port In and Serial Port Out. The available options are 1200, 2400, 4800, 9600, 19200,
38400, 57600, and 115200.
Reset
Reset all network settings to default factory values.
72 English
Projector
(Ethernet)