Save To User; Apply To User; Reset - Optoma ZU1100 User Manual

USING THE PROJECTOR
If neither of the two methods described above solved the problem, please use another 3D IR emitter/3D RF
emitter or try any of the following two methods.
‡ Use a wired remote-in cable for the IR control.
‡ Use the IR control via the HDBaseT device (not supplied).
Note:
Disable the Front/Top remote receivers and enable the HDBaseT for IR control in the OSD menu >
Communication > Remote Setup > IR Function.
3D Invert
When the 3D video does not appear correctly, use this function to invert the 3D left and right frames.
Frame Delay
Set a frame delay value for the projector to correct the time difference between the 3D signal being given
and the result being executed. This function works only when L/R Reference is set to Field GPIO. When
performing 3D blending on multiple projectors, set the frame delay for each projector to correct the non-
synchronous images.

Reset

Reset the function settings to factory default values.

Save to User

Save the image settings to the User mode.

Apply to User

Apply the image settings to User-Presentation, User-Bright, User-Cinema, User-HDR, User sRGB, User-DICOM
SIM., User-Blending, User-3D, or User-2D High Speed.
Reset
Reset all 3D settings.
53
English