Table of Contents
Advertisement
USING THE PROJECTOR
Communication menu
Communication menu is used to configure the settings that allow the projector to communicate with other projectors
or control devices.
Submenus
‡
Projector ID
‡
Remote Setup
‡
Network Setup
‡
Email Notification
‡
Control
‡
Baud Rate
Supplemental information
‡
Using the web control panel
‡
Using RS232 command by Telnet
Projector ID
Assign an ID code for the projector from 00 to 99. Use this code as the projector ID when controlling the projector
by RS232, HDBaseT, Telnet or other control methods.
Remote Setup
Configure the settings of the Infra-Red (IR) remote control.
Remote Code
Set the remote custom code by pressing the remote ID button for 3 seconds and you will notice the remote indicator
(above the Off button) starts blinking. Then, input a number between 00-99 using the keyboard numbered keys.
After inserting the number, the remote indicator blinks twice quickly indicating that the remote code has changed.
For more information on remote codes, refer to "Remote control ID setup" on page 27.
Quick Switch Code
The IR receiving function of the projector can be temporarily deactivated by hot key(0~9) to avoid the IR
interference between projectors. The remote ID needs to be set to All.
Note:
When hotkey is on, the default functions are inactive temporarily.
IR Function
Set the remote receiver for the projector to control the communication between the projector and the IR
remote.
‡
Front: Enable or disable the front remote receiver.
‡
Top: Enable or disable the top remote receiver.
‡
HDBaseT: Select On to set the HDBaseT terminal as the remote receiver.
User 1 / User 2
Assign a function to the User 1 and User 2 buttons on the remote control. It allows you to use the function
easily without going through the OSD menus. The available functions are Freeze Screen, Blank Screen, PIP/
PBP, Aspect Ratio, Information Hide, Network Setup, Projector ID, Color Matching, and Reset Selective.
70
English
Advertisement
Table of Contents
