Optoma ZU1100 User Manual page 22

SETUP AND INSTALLATION
5. Zone D/E boresight adjustment.
If zone D is in focus on the screen, please check the focal plane of zone E.
‡ If clear position is just on the screen then no need to adjust.
‡ If clear position is out of the screen (close to the projector), rotate screw
screw
For example, turn
‡ If clear position is in the screen (away from the projector), rotate screw
1
6. Zone H/I boresight adjustment.
If zone H is in focus on the screen, please check the focal plane of zone I.
‡ If clear position is just on the screen then no need to adjust.
‡ If clear position is out of the screen (close to the projector), rotate screw
screw
example, turn
‡ If clear position is in the screen (away from the projector), rotate screw
1
22 English
& CW for half amount that
1 3
CCW in a circle, then turn
2
& CCW for half amount that
3
2
& CW for half amount that
1 2
CCW in a circle, then turn
3
& CCW for half amount that
2
2
rotated. Then repeat until both D and E are clear.
2
&
1
rotated. Then repeat until both D and E are clear.
2
3
1
rotated. Then repeat until both H and I are clear. For
3
& CW in half circle).
1 2
rotated. Then repeat until both H and I are clear.
3
3
1
CCW and then
2
CW in half circle).
3
CW and then screw
2
3
1
CCW and then
3
CW and then screw
3
3
1
2
2