Optoma ZU1100 User Manual page 52

USING THE PROJECTOR
3D Tech
Select a proper 3D technology according to how the 3D sync signal is processed.
‡ DLP-Link: Select DLP-Link when the 3D sync signal is generated by the DLP Link technology built
into the projector. DLP Link works only with the glasses that are compatible with DLP 3D technology
and the 3D function is enabled
‡ 3D Sync: Select 3D Sync when the 3D sync out signal is sent to an emitter or another projector
through the 3D sync out port.
3D-2D
Transform the 3D content to 2D images.
‡ 3D: Play the 3D content normally.
‡ L: Play the left images of the 3D content.
‡ R: Play the right images of the 3D content.
3D Sync Out
Set up the transmission of the 3D sync output signal.
‡ To Emitter: Send the 3D sync signal to the emitter connected to the 3D sync out port.
‡ To Next Projector: Send the 3D sync signal to next projector when using multiple projectors.
IR Control setup when using the 3D IR emitter
Infrared devices interfere with each other if placed in the same sensing angle. If you want to use the 3D IR
emitter and the IR remote function, do any of the following:
‡ Place the 3D IR emitter outside the IR remote control sensing angle as shown below:
3D IR emitter direction
‡ Based on the room layout, disable either the front or the top remote receiver in the OSD menu >
Communication > Remote Setup > IR Function menu to avoid the 3D IR emitter interference, yet
allowing to use the IR remote control function.
52 English
3D IR emitter direction
NG
Horizontally or
Vertically ± 30°
Horizontally or Vertically
± 30°
OK
3D IR emitter direction
NG