Selecting An Input Source - Optoma ZU1100 User Manual

USING THE PROJECTOR
Powering off
1. Turn off the projector by pressing the power button "
on the remote control.
A message will pop up to confirm that you want to turn off the projector.
Press the power button or the OFF button again to confirm, otherwise the warning message
2.
disappears after 10 seconds and the projector remains on.
3. Set the Power switch to the "o" (OFF) position.
The status LED turns from blinking orange to solid orange and the keypad also turns to solid orange.
4. Disconnect the power cord from both the projector and the electrical outlet.
Note:
It is not recommended to turn on the projector immediately after powering it off. Wait for 10 seconds until
you power it on again.

Selecting an input source

Turn on the connected source that you want to display on the screen, such as computer, notebook, and/or video
player. The projector will automatically detect the input source. If multiple sources are connected, press the INPUT
button on the remote control or INPUT key on the projector keypad to select an input source.
" on the projector keypad or the OFF button "
or
"
31
English