Start-Up And Operating Instructions; Auger Assembly Breakdown - Cornelius The Profile PR150 BC Operator's Manual

START-UP AND OPERATING INSTRUCTIONS

Fill the hopper with ice. Dispense a large cup of ice. Repeat this procedure when ever the dispenser has run out of ice.
In normal operation, pushing the ice dispenser lever will cause ice to flow from the ice chute. Ice flow will continue to
flow as long as the lever is held depressed.
If the dispenser fails to dispense beverage or ice, refer to Troubleshooting section of this manual.
A A
UGER SSEMBLY
1. For cleaning, the auger assembly is constructed for simple (tools not required) breakdown. First remove
the tower cover (Item 69) by removing the 2 knurled screws.
2. Once the tower cap is out of the way you will see a wire retainer (Item 77). By placing your fingers on the
backside of the ice chute (Item 65) with your thumbs pointing upward, place the thumbs on the retainer
wire and with a slight upward movement push the wire retainer towards the rear of the unit. The retainer
should pop out of the saddle and swing backwards.
3. At this point, you should be able to pull up on the ice chute and remove it from the assembly. You will notice
that the ice chute is made up of three pieces. That is the ice chute, the ice chute cover and the auger gate
which is respectively (Items 65, 66, and 67). Take not so that when reassembling the ice chute, the auger
gate cradles in the ice chute with the short tang side up.
4. The auger (Item 73) can now be removed by just grasping it and pulling up. Notice that the bottom of the
auger has a depression in the form of a D pattern. When replacing the auger, it will be necessary to rotate
the auger after insertion in the tube to engage the motor shaft.
©2001-2010, IMI Cornelius Inc.
B
REAKDOWN
67
65
77
Figure 4. Auger Assembly
PR150 BC Ice Drink Dispenser Operator's Manual
69
66
73
- 11 - Publication Number: 620918702