NEC Express5800/R120g-1E Maintenance Manual page 114

Chapter 2 Useful Features
Item
Alert Level
Alert Level
Alert Test
*1: When Mail Alert is enabled, at least one address should be enabled.
*2: Can be specified only when To:X is set to "Enable".
*3: Up to 255 characters including alphanumeric, hyphen, underscore, period, and @ (at mark) can be used.
*4: Up to 63 alphanumeric characters excluding +, ", ?, =, <, >, #, and ¥ can be used.
*5: Up to 255 alphanumeric characters, hyphen, and period can be used for full domain name or IP address.
*6: Can be specified only when SMTP Authentication is set to "Enable".
*7: When SMTP Authentication is set to "Enable", at least one of the authentic method should be enabled.
*8: Up to 64 alphanumeric characters can be used excluding " " blank, ",?, =, <, >, #, and ¥.
*9: Up to 19 alphanumeric characters can be used excluding " " blank, ",?, =, <, >, #, and ¥.
*10: Be sure to perform Alert Test after all the parameters are configured appropriately. Alert feature may fail depending on
configuration made for network or alert receiver.
114
Specify the kind of event to alert.
Error
: When "Error" is detected in each sensor type, the alert is sent to the
selected address among To1 to To3.
Error, Warning
: When "Error" or "Warning" is detected in each sensor type, the alert is sent
to the selected address among To1 to To3.
Error, Warning, Information
: When "Error", "Warning" or "Information" is detected in each sensor type,
the alert is sent to the selected address among To1 to To3.
Separate Setting
: You can arbitrarily select the event and the address (To:X) to alert in each
sensor type.
Execute test by sending an alert by mail.
Express5800/R120g-1E Maintenance Guide
Description
*10
2. Server Configuration
(2/2)
Default Value
Error, Warning
–