NEC Express5800/R120g-1E Maintenance Manual page 144

Chapter 2 Useful Features
4. Create a virtual drive. The procedure for creating a new virtual drive is different from that for adding a
virtual drive. Creating a new virtual drive is to create a virtual drive by using a new physical device.
Adding a virtual drive is to create an additional virtual drive by using an unused area of the existing
Drive Group.
The procedures to create the virtual drive in each case are following below.
4-1. New creation (RAID0/RAID1)
1)
2)
144
Note • Up to eight virtual drives can be created.
•
For RAID10, only creating a new virtual drive is available.
•
For RAID10, the virtual drive is configured with the maximum capacity. You cannot
specify the capacity.
On the screen shown in step 3, select "Unconfigured Capacity" for Select Drives From.
Select Select Drives, and then select the device type for Select Media Type.
•
Note Do not select Both. This platform does not support Both of Media Type.
•
The options for Select Media Type vary depending on the connected device.
Express5800/R120g-1E Maintenance Guide
4. RAID System Configuration