NEC Express5800/R120g-1E Maintenance Manual page 204

Chapter 3 Appendix
b57nd60a
4
When installing an OS, starting system,
or applying Starter Pack
l2nd
4
When starting system, or applying
Starter Pack
l2nd
4
When installing an OS, starting system,
or applying Starter Pack
Megasas
11
When applying Starter Pack
mlx4_bus
24
At the time of system start-up
ixgbi
27
When installing an OS
ixgbs
27
When starting system, or applying
Starter Pack
ixgbt
27
When starting system, or applying
Starter Pack
volmgr
46
When installing an OS
204
Broadcom NetXtreme Gigabit Ethernet #xx: The network link is down.
Warning
Check to make sure the network cable is properly connected.
This event does not affect system operation.
QLogic BCM57800 #xx: The network link is down.
Warning
Check to make sure the network cable is properly connected.
This event does not affect system operation.
QLogic BCM57810 #xx: The network link is down.
Warning
Check to make sure the network cable is properly connected.
This event does not affect system operation.
Error The driver detected a controller error on \Device\RaidPort(x).
This event does not affect system operation if it is logged when applying
Starter Pack.
MLX4_SF_32_0_0:
Problem - The port was configured to use auto sensing for deciding the
port type. Port * failed to detect the port type automatically.
Impact - As a result the port is being started as an IB port (unless the
port is ETH only). This may cause a connection problem if the other side
is an ETH port.
Warning
Reason and suggestion to fix - This problem may happen since the
computer is connected back to back or the cable is unplugged.
To solve this issue connect the port to a switch or define the port type
explicitly (IB or ETH) instead of auto.
* There may be cases that the above message is somewhat different.
This event is logged in the system when InfiniBand Adapter is
connected.
This event will be recorded when the type of port could not be
recognized automatically such as InfiniBand cable is not connected.
Intel(R) Ethernet Controller X540-AT2 #xx
Warning
Network link is disconnected.
This event does not affect system operation.
Intel(R) Ethernet Controller X550 #xx
Warning
Network link is disconnected.
This event does not affect system operation.
Intel(R) Ethernet Controller X540-AT2 #xx
Warning
Network link is disconnected.
This event does not affect system operation.
Error Crash dump initialization failed!
Go to the following Microsoft website for details.
http://support.microsoft.com/kb/2756313
Express5800/R120g-1E Maintenance Guide
2. List of Windows Event Logs