NEC Express5800/R120g-1E Maintenance Manual page 30

Chapter 1 Maintenance
 Did you configure the RAID controller?
→
For a RAID system, use EXPRESSBUILDER or RAID Configuration Utility (Off-line Utility or LSI
Software RAID Configuration Utility) to properly configure the RAID controller before installing OS.
 Did you create a logical drive?
→ For a RAID system, create a logical drive using EXPRESSBUILDER or RAID Configuration Utility
(Off-line Utility or LSI Software RAID Configuration Utility) to install OS.
[?] Unable to install Windows
 Did you check the precautions for installation?
→ For installing OS, see "Installation Guide (Windows)".
[?] A product key is not requested
 Did you use the backup DVD-ROM?
→
You do not need to type the product key when installing Windows with the backup DVD-ROM.
[?] The following devices are indicated as faulty devices in a Windows Server 2012 R2 / Windows Server 2012
Server Core installation environment
•
SM Bus Controller
•
Base System Device
•
System Interrupt Controller
• Performance Counters
• PCI Device
•
PCI Simple Communications Controller
→
There is no operational problem.
[?] The following message appears when installing OS, and cannot proceed
→
The USB optical disk drive is connected to USB3.0 port. Connect an optical disk drive to USB2.0 port.
See Chapter 1 (4. Names and Features of Component) in User's Guide.
[?] Unable to access the partition which was previously created after reinstalling while several disks are
connected
→
For details, refer to the Microsoft website below:
http://support.microsoft.com/kb/2497048/ja
30
(Japanese only)
Express5800/R120g-1E Maintenance Guide
5. Troubleshooting