Table of Contents
Advertisement
User manual
P/N 3-9008-507
Note
Observe the differences between upstream and downstream cones.
5. Insert the internal assembly downstream spring clip, assembly end first, into the
upstream end of the meter housing bore. Push the internal assembly into the bore
contacting the shoulder on the downstream end of the housing bore. Rotate the
downstream spring and assembly to align the three tubes with the three tubes of
the upstream spring clip assembly.
Figure 9-19: Internal assembly installation
6. Install the sleeve and retainer ring in the groove in the upstream end of the housing
bore. Tang side of the retainer ring is to be inserted last to provide for future
disassembly.
Figure 9-20: Sleeve and retainer ring installation
User manual
USER MANUAL
Planned maintenance
September 2020
89
79
www.Daniel.com
Advertisement
Table of Contents
