Table of Contents
Advertisement
7 - Operation
D
ynamic display behaviour
• If the MPPT scan function is enabled, icon b09 will be shown on the di-
splay. See configuration in the MPPT section of the Settings menu. This
icon will flash during scanning.
• During operation, the following values are displayed in rotation:
- Voltage and current (b15 and b16) from the PV generator. Depending
on the configuration or model of the inverter, the voltages and currents of
one or both channels will be displayed. The input channel considered is
indicated by the value included in icon b14.
- Voltage and current (b19 and b20) in the various phases. Depending on
DC
the ACDC model of the inverter, the voltages and currents of one (1) or
AC
three phases (1,2,3) will be displayed. The phase considered is shown to
the right of the voltage and current values.
At the end of the aforesaid display, the grid frequency will be indicated
in field b20 and the phase-to-phase voltage will be indicated in field b19.
ESC
UP
DOWN
ENTER
At the same time, the main readings made by the inverter will be displa-
yed in rotation on the graphic display b10.
• Display of the power graph b11.
The histogram allows for 16 horizontal units and 20 vertical units.
Time is represented along the horizontal axis of the graph and can be
set by the user to 8, 16 or 24 hours; therefore, each horizontal unit can
represent 30, 60 or 120 minutes.
Output power is represented on the vertical axis, with 100% correspon-
ding to the maximum power that can be exported by the inverter to the
grid.
Finally, bear in mind that the power value expressed by each column of
the graph represents the average value of the power during the period
relating to the horizontal unit.
- 76 -
Advertisement
Table of Contents
